Baxter 2B0822 - Potassium Chloride Injection, Highly Concentrated, 20 mEq/ 50 ml, Viaflex Plastic Container, 24/cs (Rx) (Continental US Only, Excluding IN and ND)

Baxter 2B0822 - Potassium Chloride Injection, Highly Concentrated, 20 mEq/ 50 ml, Viaflex Plastic Container, 24/cs (Rx) (Continental US Only, Excluding IN and ND)

Baxter 2B0822 Potassium Chloride Injection, Highly Concentrated, 20 mEq/ 50 ml, Viaflex Plastic Container

This Potassium Chloride Injection, is a sterile, nonpyrogenic, highly concentrated, ready-to-use, solution of Potassium Chloride, USP in Water for Injection, USP for electrolyte replenishment in a single dose container for intravenous administration. It contains no antimicrobial agents.

This VIAFLEX Plus plastic container is fabricated from a specially formulated polyvinyl chloride (PL 146 Plastic). Exposure to temperatures above 25C/77F during transport and storage will lead to minor losses in moisture content. Higher temperatures lead to greater losses. It is unlikely that these minor losses will lead to clinically significant changes within the expiration period. The amount of water that can permeate from inside the container into the overwrap is insufficient to affect the solution significantly. Solutions in contact with the plastic container may leach out certain of its chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the plastic container materials.

Indications and Usage of Baxter 2B0822

Potassium Chloride Injection is indicated in the treatment of potassium deficiency states when oral replacement is not feasible.

THIS HIGHLY CONCENTRATED, READY-TO-USE POTASSIUM CHLORIDE INJECTION IS INTENDED FOR THE MAINTENANCE OF SERUM K+ LEVELS AND FOR POTASSIUM SUPPLEMENTATION IN FLUID RESTRICTED PATIENTS WHO CANNOT ACCOMMODATE ADDITIONAL VOLUMES OF FLUID ASSOCIATED WITH POTASSIUM SOLUTIONS OF LOWER CONCENTRATION.

When using these products, these patients should be on continuous cardiac monitoring and frequent testing for serum potassium concentration and acid-base balance.

Baxter 2B0822 Dosage and Administration

he dose and rate of administration are dependent upon the specific condition of each patient.

Administer intravenously only with a calibrated infusion device at a slow, controlled rate. Highest concentrations (400 mEq/L) should be exclusively administered via central intravenous route. Whenever possible, administration via a central route is recommended for all concentrations of Potassium Chloride Injection for thorough dilution by the blood stream and decreasing the risk of extravasation and to avoid pain and phlebitis associated with peripheral infusion. Correct placement of the catheter should be verified before administration.

Recommended administration rates should not usually exceed 10 mEq per hour or 200 mEq for a 24 hour period if the serum potassium level is greater than 2.5 mEq per liter.

In urgent cases where the serum potassium level is less than 2.0 mEq per liter or where severe hypokalemia is a threat, (serum potassium level less than 2.0 mEq per liter and electrocardiographic changes and/or muscle paralysis) rates up to 40 mEq per hour or 400 mEq over a 24 hour period can be administered very carefully when guided by continuous monitoring of the EKG and frequent serum K+ determinations to avoid hyperkalemia and cardiac arrest.

Parenteral drug products should be inspected visually for particulate matter and discoloration, whenever solution and container permit. Do not administer unless solution is clear and seal is intact. Use of a final filter is recommended during administration of all parenteral solutions where possible.

Do not add supplementary medication.